xebanhmi6

™

Rice may be cooked by 3 methods, each of which requires a different proportion of water. These methods are boiling, which requires 12 times as much water as rice; the Japanese method, which requires 5 times as much; and steaming, which requires 2-1/2 times as much. Whichever of these methods is used, however, it should be remembered that the rice grains, when properly cooked, must be whole and distinct. To give them this form and prevent the rice from having a pasty appearance, this cereal should not be stirred too much in cooking nor should it be cooked too long.

BOILED RICE – Boiling is about the simplest way. Properly boiled rice not only forms a valuable dish itself, but is an excellent foundation for other dishes that may be served at any meal. The water in which rice is boiled should not be wasted, as it contains much nutritive material. This water may be utilized in the preparation of soups or sauces, or it may even be used to supply the liquid required in the making of yeast bread.

BOILED RICE (Sufficient to Serve Eight)

1 c. rice ; 3 tsp. Salt; 3 qt. boiling water

Wash the rice carefully and add Xe cà phê it to the boiling salted water. Boil rapidly until the water begins to appear milky because of the starch coming out of the rice into the water or until a làm xe bánh mì chả cá grain can be easily crushed between the fingers. Drain the cooked rice through a colander, and then pour cold water over the rice in the colander, so as to wash out the loose starch and leave each grain distinct. Reheat the rice by shaking it over the fire, and serve hot with butter, gravy, or cream or milk and sugar.

JAPANESE METHOD – Rice prepared by the Japanese method may be used in the same ways as boiled rice. However, unless some use is to be made of the liquid from boiled rice, the Japanese method has the advantage of being a more economical way of cooking this cereal.

JAPANESE METHOD (Sufficient to Serve Eight)

1 c. rice ; 1-1/2 tsp. Salt; 5 c. boiling water

Wash the rice, add it to the boiling salted water, and boil slowly for 15 minutes. Then cover the utensil in which the rice is cooking and place it in the oven for 15 minutes more, in order to evaporate the water more completely and make the grains soft without being mushy. Serve in the same way as boiled rice.

STEAMED RICE – To steam rice requires more time than either of the preceding cooking methods, but it causes no loss of food material. Then, too, unless the rice is stirred too much while it is steaming, it will have a better appearance than rice cooked by the other methods. As in the case of boiled rice, steamed rice may be used as the foundation for a variety of dishes and may be served in any meal.

STEAMED RICE (Sufficient to Serve Six)

1 c. rice; 1-1/2 tsp. Salt 2-1/2 c. water

Wash the rice carefully and add it to the boiling salted water. Cook it for 5 minutes and then place it in a double boiler and allow it to cook until it is soft. Keep the cooking utensil covered and do not stir the rice. About 1 hour will be required to cook rice in this way. Serve in the same way as boiled rice.

™

Cleaning trout. Does that bring back memories! I think I was about 9 years old when I first learned how to clean trout. It is really pretty easy. A little practice and làm xe bánh mì chả cá you will soon be cleaning trout with ease. If at all possible, use clean, running water to rinse the trout as you clean.

Scaling the trout.

For this step, you will need a fish-board with a clip to hold the tail or you can hold the tail with your hand. You will also need a fish scaler or use the unsharpened side of a good sturdy knife (short blade is best). With the trout held firmly by the tail, scrape very firmly from the tail to the gills several times on both sides. This will remove the scales so you dont have to deal with them later. No one wants to find them in a bite of grilled fish!

Gutting the trout.

To properly gut the trout without tearing into the stomach or intestines, you will need a sharp, short bladed knife. The short blade gives you better control. The first cut you want to make is just at gill level from the belly side. This results in a cut between the jawbone and the tongue. Do not cut through the spine. Next, place 1 or 2 fingers inside the trouts mouth with the palm of your hand pressed firmly on the top of its head and your thumb in the gill to hold it solid. Then, carefully, begin to slit the trouts belly starting at the anus and working your way up to the cut under the gills. You need to be careful not to cut into the guts themselves, as this will foul the flesh, making it inedible. Keep your knife just under the skin. To pull the guts out, hold the trout firmly with your thumb under the jaw and your index finger in the mouth. Then get a firm grip on the guts and pull them out. All that is left to do is to scrape your thumb along the spine in the gut cavity to clean out the bloodline.

To behead or not to behead.

This last step can be a matter Xe cà phê of personal preference. Removing the head of the trout. Some people like it left on, but, personally, I dont like my food looking back at me.

To do this, you need a good sturdy knife. The same one you used to cut the belly open will work. Just be sure to rinse it good first. To cut the head off, grasp the trout firmly in the middle with your thumb in the gut cavity and the rest of your hand wrapped around it. Hold the trout so that the head is pushed down on your cutting surface. With your knife, make a firm slicing motion through the spine at gill level, preferablywith the gut cavity up. Once this is complete, rinse the trout and you are ready to proceed with the rest of your trout cleaning.

Of course, you could use my favorite method to clean a trout. Filet it!